The installation of ceramic tile
ceramic tile
I wanted my new ceramic tile bathroom again. Floor tiles, I always thought that there were no longer needed, and I never understood why the carpet had continued from the hall to the bathroom. I knew it was inevitable tiled floors, was only a matter of time. First I had to pull the rug ugly color. Fortunately, my plan seemed less ready to be tiled: No bounce or anything. I wanted a jacket pattern on the floor, so I measured the center of the two walls and put a plaster x corresponds exactly to the center of the room. I spread my adhesive trowel, comb and then laying ceramic tiles. I used a surface solvent recommended by the manual. Then with my tile leveler and a mallet, I began the tiles in place. But when I turned the corners would have to cut some tiles to make them fit. Once marked, click the card by placing it on a nail or wire. For difficult to cut tiles, I drew a line I wanted to follow, marked, then cross the lines marked in an area delineated and started breaking them with pliers. I was careful not to break pieces too large for fear that the matter would break, and I should start. I mixed the mortar to a thick pasty consistency and forced between the tiles with a rubber spatula.
